|
|
| (15 intermediate revisions by 4 users not shown) |
| Line 1: |
Line 1: |
| − | {{Infobox|This is a BETA target and not yet available. This wiki page will continue to be updated until release. }}
| + | == Page Moved == |
| | | | |
| − | This target is for the ATMega2564RFR2. This makes a great target for exploring IoT technologies, such as mesh networking protocols.
| + | See [https://rtfm.newae.com/Targets/UFO%20Targets/CW308T-ATMega1284RFR2/ NewAE RTFM Page] which is now built from the [https://github.com/newaetech/chipwhisperer-target-cw308t GIT Repo]. |
| | | | |
| − | [[File:meagrf_render_02.png|400px]]
| + | The previous content on this wiki has been moved to the above link. See wiki history if you would like to view exact older versions of this page. |
| − | | + | |
| − | == Programming ==
| + | |
| − | | + | |
| − | The ChipWhisperer's AVR programmer supports this target directly. No external programmer is required. | + | |
| − | | + | |
| − | == Schematic ==
| + | |
| − | | + | |
| − | See GIT Repo for PDF of schematic. | + | |
| − | | + | |
| − | [[File:CW308T_ATMegaRF_02.png|1000px]]
| + | |
| − | | + | |
| − | == Board Layout ==
| + | |
| − | | + | |
| − | See GIT Repo for gerber files.
| + | |
| − | | + | |
| − | == Radio Usage ==
| + | |
| − | | + | |
| − | Note NO ANTENNA is provided as the board is sold only as a sub-assembly and not designed to be used as a radio transmitter. Mounting a 2.4 GHz radio antenna (SMA, NOT reverse-polarity SMA) like Digi-Key P/N 1475-1014-ND could potentially require you to meet FCC/CE guidelines for RF emissions and is UNSUPPORTED USAGE.
| + | |
| − | | + | |
| − | == Historical Note ==
| + | |
| − | | + | |
| − | The following is the original (-01) schematic. The -01 PCBs were never publicly released and used during development only. The following changes were made in -02:
| + | |
| − | | + | |
| − | * MOSI/MISO was switched on Atmel device (requires PCB fix on -01, or PCB will not work)
| + | |
| − | * TST connected to ground (requires PCB fix on -01, or PCB will not work)
| + | |
| − | * CLKI pull down
| + | |
| − | * GPIO3 is now optionally in control of 4066 instead of being hardwired
| + | |
| − | * Serial resistors added on SCK/MISO/MOSI lines
| + | |
| − | | + | |
| − | [[File:CW308T_ATMegaRF_01.png|200px]]
| + | |
| − | | + | |
| − | [[Category:Targets]]
| + | |
| − | [[Category:CW308 Targets]]
| + | |