The CW308 UFO Board is a handy main-board for attacking all sorts of embedded targets. Released in 2016, it forms the basis for most of our upcoming target boards. It can be used stand-alone (with an oscilloscope) or with the ChipWhisperer-Capture hardware.== Page Moved ==
== Overview == == Victim Board Connectors == The "victim board" fits into three 20-pin female headersSee [https://rtfm. They provide both electrical and mechanical connections for the boardnewae. There is optional mounting holes which can be used if additional mechanical support is required (especially if you need a locked-down victim for use with an EM probe). == Icom/O Connections == There are two main ITargets/O connection points: the pin headers which duplicate the target board connections, and the 20-pin ChipWhisperer headerCW308%20UFO/ NewAE RTFM Page]. The ChipWhisperer header pins (most of the pins previous content on header J5) have diode protection this wiki has been moved to set a maximum voltage level. The maximum voltage is set by the voltage present on the middle pin of J4above link. == Clock Network == === Clock Selection === === Crystal Driver === == Power Distribution == === External Power Sources === === On-Board LDOs === == Programmer Connections == == Jumper Summary == == Schematic == The schematic is available in PDF format here: . The following has a copy See wiki history if you would like to view exact older versions of schematic pages in image as well: [[File:NAE-CW308-03_Schematic_Page_1this page.png|1200px]] [[File:NAE-CW308-03_Schematic_Page_2.png|1200px]] [[File:NAE-CW308-03_Schematic_Page_3.png|1200px]] [[File:NAE-CW308-03_Schematic_Page_4.png|1200px]] [[File:NAE-CW308-03_Schematic_Page_5.png|1200px]]