The CW308 UFO Board is a handy main-board for attacking all sorts of embedded targets. Released in 2016, it forms the basis for most of our upcoming target boards. It can be used stand-alone (with an oscilloscope) or with the ChipWhisperer-Capture hardware.== Page Moved ==
== Overview == == Victim Board Connectors == The "victim board" fits into three 20-pin female headersSee [https://rtfm. They provide both electrical and mechanical connections for the boardnewae. There is optional mounting holes which can be used if additional mechanical support is required (especially if you need a locked-down victim for use with an EM probe). == Icom/Targets/O Connections == There are two main ICW308%20UFO/O connection points: the pin headers which duplicate the target board connections, and the 20-pin ChipWhisperer headerNewAE RTFM Page]. The ChipWhisperer header pins (most of the pins previous content on header J5) have diode protection this wiki has been moved to set a maximum voltage levelthe above link. The maximum voltage is set by the voltage present on the middle pin See wiki history if you would like to view exact older versions of J4this page. == Clock Network == === Clock Selection === === Crystal Driver === == Power Distribution == === External Power Sources === === On-Board LDOs === == Programmer Connections == == Jumper Summary == == Schematic == The schematic is available in PDF format here: . The following has a copy of schematic pages in image as well: